# OBD-II P0127: Intake Air Temperature Too High

> **Quick Answer:** OBD-II fault code P0127 indicates Intake Air Temperature Too High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$1296.

- **URL:** https://faultcodes.org/automotive/obd2-p0127
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0127 is not a circuit fault but a functional check of the air path: the measured intake air temperature is too high for the operating state. The logic is documented for a Bosch EDC16 diesel (Saab 9-3): if the intake air exceeds 130 °C and does not fall below it within 45 s after the exhaust gas recirculation valve is closed, hot exhaust gas is evidently still entering or the sensor is wrong. The engine then disables EGR and runs in limp mode with reduced torque. GM has the code in its diesel software but disabled for US OBD II; Ford reports an overly hot intake air reading as P0111 instead. On other engines a hot reading can also come from warm under-bonnet air being drawn in.

## Common Symptoms
- Check engine light on
- Loss of power, limp mode with torque limit
- EGR switched off
- Knock tendency and retarded ignition on petrol engines

## Most Likely Root Causes
- EGR valve stuck open or not sealing (diesel)
- EGR cooler clogged or bypass flap stuck in bypass
- Charge air cooler dirty or airflow through it blocked
- Sensor reading wrong, or hot engine-bay air drawn in (loose intake duct)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Intake Air Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Intake Air Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0127 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$544 | $54–$1296 |
| GBP | £15–£428 | £43–£1032 |
| CAD | CA$26–CA$731 | CA$73–CA$1740 |
| EUR | €18–€504 | €50–€1200 |
| CHF | CHF 21–CHF 580 | CHF 66–CHF 1584 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0127?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0127?
DIY replacement parts average $19–$544, while professional service averages $54–$1296.

### Will resetting P0127 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

