# OBD-II P0122: Throttle/Pedal Position Sensor/Switch A Circuit Low

> **Quick Answer:** OBD-II fault code P0122 indicates Throttle/Pedal Position Sensor/Switch A Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$486.

- **URL:** https://faultcodes.org/automotive/obd2-p0122
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor A is, in practice, throttle position sensor 1 at the throttle body; the accelerator pedal has its own codes (P2120 onwards). With a cable-operated throttle there is a single potentiometer (about 0.5 V closed to 4.5 V wide open). Electronic throttles have two sensors sharing a 5 V reference and ground, usually running in opposite directions – on GM throttle sensor 1 falls from 3–4 V at idle to below 1 V at full throttle. P0122 means the signal voltage of sensor A is below its lower limit – electrically meant, not 'throttle closed': typically an open or grounded signal wire or a missing 5 V reference. Limits: Ford below 0.25 V (detected within 1 s), Saab/GM 2011 below 0.3 V for 1 s, Saab cable system below 0.2 V for 5 s. GM treats it as a one-trip fault and switches to reduced engine power; Ford lights the MIL and wrench lamp and continues on the remaining sensor or in limp mode.

## Common Symptoms
- Check engine light, on electronic throttles also wrench lamp
- Limp mode with reduced power ('Reduced Engine Power') on electronic throttles
- Engine barely responds to the pedal or stalls at idle
- High idle, A/C switched off (cable systems)

## Most Likely Root Causes
- Signal wire open or shorted to ground
- Connector at the throttle body loose or corroded
- 5 V reference missing (open, or shorted by another sensor)
- Sensor or throttle body faulty
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Throttle Position Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Throttle Position Sensor.
5. Clear fault memory and run a verification cycle to confirm P0122 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$204 | $43–$486 |
| GBP | £13–£161 | £34–£387 |
| CAD | CA$22–CA$274 | CA$58–CA$653 |
| EUR | €15–€189 | €40–€450 |
| CHF | CHF 17–CHF 217 | CHF 53–CHF 594 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0122?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0122?
DIY replacement parts average $16–$204, while professional service averages $43–$486.

### Will resetting P0122 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

