# OBD-II P0120: Throttle/Pedal Position Sensor/Switch A Circuit

> **Quick Answer:** OBD-II fault code P0120 indicates Throttle/Pedal Position Sensor/Switch A Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$486.

- **URL:** https://faultcodes.org/automotive/obd2-p0120
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor A is, in practice, throttle position sensor 1 at the throttle body; the accelerator pedal has its own codes (P2120 onwards). With a cable-operated throttle there is a single potentiometer (about 0.5 V closed to 4.5 V wide open). Electronic throttles have two sensors sharing a 5 V reference and ground, usually running in opposite directions – on GM throttle sensor 1 falls from 3–4 V at idle to below 1 V at full throttle. P0120 is the general circuit fault, used when the fault cannot be classed as low or high or when the sensor is digital. Ford sets it on digital SENT throttle sensors when the sensor reports an error for more than 4 s, together with the MIL and wrench lamp; Saab Trionic used it as a collective code. GM and Ford's analogue throttles report P0122/P0123 instead. Electronic throttles then fall back to a spring-loaded limp position with limited power.

## Common Symptoms
- Check engine light, on electronic throttles also wrench lamp
- Limp mode with reduced power ('Reduced Engine Power') on electronic throttles
- Raised or unsteady idle (cable systems)
- Poor throttle response, jerky driving

## Most Likely Root Causes
- Connector at the throttle body corroded or loose, broken wire
- Sensor or throttle body with integrated sensor faulty
- 5 V reference disturbed (short on another sensor of the same circuit)
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Throttle Position Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Throttle Position Sensor.
5. Clear fault memory and run a verification cycle to confirm P0120 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$204 | $43–$486 |
| GBP | £13–£161 | £34–£387 |
| CAD | CA$22–CA$274 | CA$58–CA$653 |
| EUR | €15–€189 | €40–€450 |
| CHF | CHF 17–CHF 217 | CHF 53–CHF 594 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0120?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0120?
DIY replacement parts average $16–$204, while professional service averages $43–$486.

### Will resetting P0120 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

