# OBD-II P011E: Engine Coolant Temperature 1 / Ambient Air Temperature Correlation

> **Quick Answer:** OBD-II fault code P011E indicates Engine Coolant Temperature 1 / Ambient Air Temperature Correlation. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p011e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
After a long standstill, typically six to eight hours, the coolant should have cooled to roughly the outside air temperature measured by the ambient sensor in the bumper or mirror. P011E compares coolant temperature sensor 1 with the ambient sensor at start-up and is set when they differ beyond a calibrated limit and no preheater was detected. The code does not say which of the two sensors is wrong. No manufacturer document using exactly this code was found; the description rests on the CARB requirement for coolant sensor plausibility and on the same cold-soak comparison that Ford (reported as P0071), GM/Saab and Mazda perform under other codes.

## Common Symptoms
- Check engine light on
- Usually no driving symptoms
- Outside temperature display possibly wrong

## Most Likely Root Causes
- Coolant temperature sensor 1 drifting
- Ambient temperature sensor drifting or affected by engine heat or sun
- Preheater not detected
- Contact resistance in one sensor's connector or wiring

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P011E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P011E?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P011E?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P011E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

