# OBD-II P011D: Charge Air Cooler Temperature/Intake Air Temperature Correlation Bank 2

> **Quick Answer:** OBD-II fault code P011D indicates Charge Air Cooler Temperature/Intake Air Temperature Correlation Bank 2. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p011d
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
This is the bank 2 counterpart of P011C and only exists on engines with two separate intake paths, each with its own charge air cooler temperature sensor and intake air temperature sensor – for example V engines with twin turbochargers and separate charge air coolers. After a long standstill both bank 2 sensors should read nearly the same; if they disagree at start-up, without either showing a circuit fault, P011D is set. The code does not identify which sensor is wrong. No manufacturer document using exactly this code was found; the check follows the same principle Ford uses for bank 1 after 6 hours, with a preheater suspending it.

## Common Symptoms
- Check engine light on
- Usually no change in driving
- Code often returns only after an overnight soak

## Most Likely Root Causes
- Bank 2 charge air cooler temperature sensor drifting, oily or stuck
- Bank 2 intake air temperature sensor drifting
- Contact resistance at connector or ground
- Undetected preheating or uneven cooling

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Charge Air Cooler Temperature Sensor Bank2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Charge Air Cooler Temperature Sensor Bank2.
5. Clear fault memory and run a verification cycle to confirm P011D does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$159 | $54–$378 |
| GBP | £15–£125 | £43–£301 |
| CAD | CA$26–CA$213 | CA$73–CA$508 |
| EUR | €18–€147 | €50–€350 |
| CHF | CHF 21–CHF 169 | CHF 66–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P011D?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P011D?
DIY replacement parts average $19–$159, while professional service averages $54–$378.

### Will resetting P011D fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

