# OBD-II P011C: Charge Air Cooler Temperature/Intake Air Temperature Correlation Bank 1

> **Quick Answer:** OBD-II fault code P011C indicates Charge Air Cooler Temperature/Intake Air Temperature Correlation Bank 1. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p011c
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
On turbocharged engines a charge air cooler temperature sensor sits downstream of the compressor, usually after the charge air cooler, and intake air temperature sensor 1 sits upstream near the air filter. While driving they differ by design, because compression heats the air. After a long standstill, however, both should read nearly the same, so the check runs at start-up. P011C is set when the two bank 1 sensors disagree there, without naming the faulty one. No manufacturer document using exactly this code was found; Ford performs the same comparison after 6 hours (tolerance about 17 °C on petrol, 16 °C on the 2023 diesel) but reports the outlier as P007B, P0111 or P00CE.

## Common Symptoms
- Check engine light on
- Usually no change in driving
- Code often returns only after an overnight soak

## Most Likely Root Causes
- Charge air cooler temperature sensor drifting, oily or stuck
- Intake air temperature sensor 1 drifting
- Contact resistance at connector or shared ground
- Undetected preheating or uneven cooling (sun, residual heat)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Charge Air Cooler Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Charge Air Cooler Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P011C does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$136 | $54–$324 |
| GBP | £15–£107 | £43–£258 |
| CAD | CA$26–CA$183 | CA$73–CA$435 |
| EUR | €18–€126 | €50–€300 |
| CHF | CHF 21–CHF 145 | CHF 66–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P011C?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P011C?
DIY replacement parts average $19–$136, while professional service averages $54–$324.

### Will resetting P011C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

