# OBD-II P011B: Engine Coolant Temperature/Intake Air Temperature Correlation

> **Quick Answer:** OBD-II fault code P011B indicates Engine Coolant Temperature/Intake Air Temperature Correlation. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p011b
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
After a long standstill the coolant and the intake air should both have settled close to ambient temperature. P011B compares the two sensors at start-up and is set when they disagree without either sensor showing a circuit fault. In the documented GM/Saab version the engine must have been off for more than 10 hours with no preheater detected; the fault counts if coolant reads at least 20 °C above intake air, or intake air at least 30 °C above coolant, and the coolant reading barely moves (2 °C or less) in the first 45 s. The code does not say which sensor is wrong – that has to be found by comparing both with the actual ambient temperature. Toyota resolved false settings on some 2015 V6 engines with new software. Ford and GM report the same idea under the individual sensor codes.

## Common Symptoms
- Check engine light on
- Usually no change in driving
- With a wrong coolant reading: poor cold start, higher consumption or odd fan behaviour
- Code often returns only after an overnight soak

## Most Likely Root Causes
- Coolant temperature sensor stuck or drifting
- Intake air temperature sensor drifting or heat-soaked
- Undetected preheater or uneven cooling
- Contact resistance at a sensor connector or ground
- Control module software (false setting, update available)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P011B does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P011B?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P011B?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P011B fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

