# OBD-II P011A: Engine Coolant Temperature Sensor 1/2 Correlation

> **Quick Answer:** OBD-II fault code P011A indicates Engine Coolant Temperature Sensor 1/2 Correlation. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$1296.

- **URL:** https://faultcodes.org/automotive/obd2-p011a
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Some engines have two coolant temperature sensors that check each other. P011A is set when both are electrically fine but their readings differ more than a calibrated amount under conditions where they should agree. Mazda documents the code for the 2013–2016 CX-5 and 2014–2016 Mazda6: sensor 2 sits in the heater hose, and a clogged heater core keeps it noticeably colder, so P011A often comes with weak cabin heat although both sensors are good. Mazda's check is to compare both sensors with ambient temperature after an overnight soak and then the temperature difference across the heater hoses. A block heater used below 0 °C can also trigger it.

## Common Symptoms
- Check engine light on
- Weak cabin heating (typical on Mazda)
- Otherwise often no driving symptoms

## Most Likely Root Causes
- Clogged heater core or restricted coolant flow at sensor 2
- One of the two sensors drifting
- Air in the cooling system or low coolant level
- Block heater use in frost
- Contact resistance at one sensor

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P011A does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$544 | $54–$1296 |
| GBP | £15–£428 | £43–£1032 |
| CAD | CA$26–CA$731 | CA$73–CA$1740 |
| EUR | €18–€504 | €50–€1200 |
| CHF | CHF 21–CHF 580 | CHF 66–CHF 1584 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P011A?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P011A?
DIY replacement parts average $19–$544, while professional service averages $54–$1296.

### Will resetting P011A fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

