# OBD-II P0119: Engine Coolant Temperature Sensor 1 Circuit Intermittent/Erratic

> **Quick Answer:** OBD-II fault code P0119 indicates Engine Coolant Temperature Sensor 1 Circuit Intermittent/Erratic. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p0119
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine coolant temperature sensor 1 is an NTC thermistor: the control module feeds 5 V through a resistor, and as the coolant warms the resistance and signal voltage fall. Its value drives cold-start enrichment, idle speed, ignition timing, the radiator fan and the release of closed-loop mixture control. Some Ford engines measure cylinder head temperature instead and calculate a coolant value from it. Coolant temperature can only change slowly because of the thermal mass involved. P0119 is set when the reading jumps faster than physically possible. GM calculates, every second, a window for the next valid value from the previous reading and a sensor time constant of 13 s; readings outside it in three of four samples count as a fault, monitored continuously over two trips. GM/Saab set it after more than 4 s of abrupt changes and then run the radiator fan. Typical causes are loose contacts or a harness chafing as the engine moves.

## Common Symptoms
- Check engine light on
- Temperature gauge jumps
- Radiator fan switches on for no reason
- Occasional rough running or idle fluctuation

## Most Likely Root Causes
- Loose contact or corroded connector pins
- Harness chafing that briefly grounds or opens with engine movement
- Sensor with internal crack or contact fault
- Air pockets at the sensor (poorly bled cooling system)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0119 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0119?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0119?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P0119 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

