# OBD-II P0116: Engine Coolant Temperature Sensor 1 Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P0116 indicates Engine Coolant Temperature Sensor 1 Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$194.

- **URL:** https://faultcodes.org/automotive/obd2-p0116
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine coolant temperature sensor 1 is an NTC thermistor: the control module feeds 5 V through a resistor, and as the coolant warms the resistance and signal voltage fall. Its value drives cold-start enrichment, idle speed, ignition timing, the radiator fan and the release of closed-loop mixture control. Some Ford engines measure cylinder head temperature instead and calculate a coolant value from it. P0116 is a plausibility fault: the signal is electrically valid but not believable. Most often it checks for a sensor stuck too warm. After a long soak (GM 8 h, Ford 6 h) coolant must be close to intake air temperature; GM fails it above about 19 °C difference without a detected block heater, Ford if it reads over 110 °C or sits at 79–110 °C. Ford diesels instead check whether coolant warms fast enough in frost. A sensor stuck warm suppresses cold-start enrichment and can defeat the thermostat monitor, which is why CARB requires this test. GM uses one or two trips depending on the engine.

## Common Symptoms
- Check engine light on
- Poor cold start (too little enrichment)
- Higher consumption or idle problems
- Often no noticeable symptoms

## Most Likely Root Causes
- Sensor drifting and reading too warm (ageing, coolant ingress)
- Corrosion or contact resistance in connector or wiring
- Block heater or preheater not detected
- Comparison sensor (intake air, ambient) wrong
- Control module calibration

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0116 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$82 | $43–$194 |
| GBP | £13–£65 | £34–£155 |
| CAD | CA$22–CA$110 | CA$58–CA$261 |
| EUR | €15–€76 | €40–€180 |
| CHF | CHF 17–CHF 87 | CHF 53–CHF 238 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0116?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0116?
DIY replacement parts average $16–$82, while professional service averages $43–$194.

### Will resetting P0116 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

