# OBD-II P0114: Intake Air Temperature Sensor 1 Circuit Intermittent/Erratic Bank 1

> **Quick Answer:** OBD-II fault code P0114 indicates Intake Air Temperature Sensor 1 Circuit Intermittent/Erratic Bank 1. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0114
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0114 covers an unsteady signal. Air temperature changes slowly, so rapid jumps point to the wiring rather than the air. Ford counts short excursions out of range that are each too brief for P0112/P0113 and sets the code after ten of them in one drive cycle. GM evaluates noise within the valid range: if the readings taken every 100 ms add up to more than 80 °C of movement within one second, in four of five seconds, the sample counts as failed. GM needs two trips. Typical culprit is a loose contact that opens with engine movement.

## Common Symptoms
- Check engine light on
- Usually no noticeable symptoms
- Occasional brief stumble or rough idle possible

## Most Likely Root Causes
- Loose contact at the connector (corrosion, weak terminal tension)
- Partly broken wire that opens with engine movement
- Sensor with internal contact problem
- Electrical interference or ground fault

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Intake Air Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Intake Air Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0114 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0114?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0114?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P0114 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

