# OBD-II P0112: Intake Air Temperature Sensor 1 Circuit Low Bank 1

> **Quick Answer:** OBD-II fault code P0112 indicates Intake Air Temperature Sensor 1 Circuit Low Bank 1. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0112
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0112 means the signal is below its valid range. With an NTC sensor that points to a short to ground in the signal wire or an internally shorted sensor, and the control module would read an implausibly hot value (GM about 150 °C). Documented limits: Ford petrol below 0.244 V for 5 s, Ford diesel below 0.10 V, GM below 62 ohms. The circuit is monitored continuously; GM needs two trips. Some systems then use the coolant temperature, capped at 40 °C, as a substitute and limit torque.

## Common Symptoms
- Check engine light on
- Usually hardly noticeable
- Retarded ignition, reduced power or torque limit on some systems
- Harder cold start possible

## Most Likely Root Causes
- Signal wire shorted to ground (chafed insulation)
- Sensor shorted internally
- Moisture or corrosion in the connector
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Intake Air Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Intake Air Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0112 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0112?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0112?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P0112 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

