# OBD-II P0111: Intake Air Temperature Sensor 1 Circuit Range/Performance Bank 1

> **Quick Answer:** OBD-II fault code P0111 indicates Intake Air Temperature Sensor 1 Circuit Range/Performance Bank 1. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0111
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0111 is a plausibility fault: the signal is electrically valid but does not fit. The usual test runs at key-on after a long soak (Ford 6 h, GM 8 h): the intake air sensor is compared with other temperature sensors such as coolant, cylinder head, charge air cooler or IAT2, which should all read about the same. GM flags it above about 25 °C deviation, Ford above about 17 °C; Ford first confirms with a drive above 40 mph because sunshine can warm a sensor, and also sets P0111 if the air reads over 66 °C while driving. A detected block heater suspends the test. Two consecutive trips are needed.

## Common Symptoms
- Check engine light on
- Usually no noticeable symptoms
- Slightly changed idle, power or cold start possible
- Code often returns only after an overnight soak

## Most Likely Root Causes
- Sensor drifting or stuck at one value (ageing, oil from crankcase ventilation)
- Contact resistance at connector or wiring distorts the reading
- Comparison sensor (coolant, IAT2, charge air cooler) wrong
- Undetected preheater, heat soak or sensor mounted near a heat source

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Intake Air Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Intake Air Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0111 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0111?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0111?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P0111 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

