# OBD-II P0110: Intake Air Temperature Sensor 1 Circuit Bank 1

> **Quick Answer:** OBD-II fault code P0110 indicates Intake Air Temperature Sensor 1 Circuit Bank 1. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0110
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0110 is the general circuit fault. With a conventional analogue sensor most manufacturers report low and high signals separately (P0112/P0113), so P0110 mainly appears in two cases: with digital (SENT) sensors that combine air mass and temperature, where it stands for lost communication or an implausible status (Ford diesel 2023, after about 5 s), and in some Bosch systems as a collective code whose fault type byte tells open circuit from short to ground. The control module then uses a substitute temperature; some systems also limit torque.

## Common Symptoms
- Check engine light on
- Reduced power or torque limitation on some systems
- Otherwise usually inconspicuous; cold start may be slightly worse

## Most Likely Root Causes
- Connector or wiring to the sensor open or corroded
- Sensor or mass air flow sensor with built-in temperature sensor faulty
- Sensor supply or ground disturbed
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Intake Air Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Intake Air Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0110 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0110?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0110?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P0110 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

