# OBD-II P010E: Mass or Volume Air Flow Sensor B Circuit Intermittent/Erratic

> **Quick Answer:** OBD-II fault code P010E indicates Mass or Volume Air Flow Sensor B Circuit Intermittent/Erratic. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p010e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor B is a second mass air flow sensor in a second intake path, found on engines with two air filter boxes – for example the Nissan VR30DDTT twin-turbo V6 (where sensor B belongs to bank 2) or GM's 3.0 litre twin-turbo V6. P010E covers brief dropouts or jumps in the signal of sensor B without a lasting low or high fault, the counterpart of P0104. Ford's 2020–2023 petrol summary sets it after more than 25 short open or short-circuit events; GM's twin-turbo V6 does not use it, and Ford does not state the trip count. The usual cause is a loose contact at the connector or a chafed wire that opens as the engine moves.

## Common Symptoms
- Check engine light on, may come and go
- Occasional hesitation or stumble
- Intermittent loss of power

## Most Likely Root Causes
- Loose contact at the sensor B connector
- Chafed or partly broken wire
- Sensor B electronics dropping out
- Poor ground or interference

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor B.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor B.
5. Clear fault memory and run a verification cycle to confirm P010E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$159 | $43–$378 |
| GBP | £13–£125 | £34–£301 |
| CAD | CA$22–CA$213 | CA$58–CA$508 |
| EUR | €15–€147 | €40–€350 |
| CHF | CHF 17–CHF 169 | CHF 53–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P010E?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P010E?
DIY replacement parts average $16–$159, while professional service averages $43–$378.

### Will resetting P010E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

