# OBD-II P010D: Mass or Volume Air Flow Sensor B Circuit High

> **Quick Answer:** OBD-II fault code P010D indicates Mass or Volume Air Flow Sensor B Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p010d
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor B is a second mass air flow sensor in a second intake path, found on engines with two air filter boxes – for example the Nissan VR30DDTT twin-turbo V6 (where sensor B belongs to bank 2) or GM's 3.0 litre twin-turbo V6. P010D means the signal of sensor B is above its electrical upper limit – the counterpart of P0103. GM's twin-turbo V6 sets it at 14,500 Hz or more (two trips); Ford's digital sensor B when the signal period drops below 83 microseconds, i.e. above roughly 12 kHz, for 5 s. Typical causes are a signal wire shorted to voltage, failed sensor electronics or interference from nearby ignition or actuator wiring. A substitute value is used.

## Common Symptoms
- Check engine light on
- Substitute value mode, lack of power
- Rich mixture and higher consumption possible

## Most Likely Root Causes
- Signal wire of sensor B shorted to voltage
- Sensor B electronics failed
- Interference from harness routing
- Control module input faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor B.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor B.
5. Clear fault memory and run a verification cycle to confirm P010D does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$159 | $43–$378 |
| GBP | £13–£125 | £34–£301 |
| CAD | CA$22–CA$213 | CA$58–CA$508 |
| EUR | €15–€147 | €40–€350 |
| CHF | CHF 17–CHF 169 | CHF 53–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P010D?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P010D?
DIY replacement parts average $16–$159, while professional service averages $43–$378.

### Will resetting P010D fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

