# OBD-II P010C: Mass or Volume Air Flow Sensor B Circuit Low

> **Quick Answer:** OBD-II fault code P010C indicates Mass or Volume Air Flow Sensor B Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p010c
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor B is a second mass air flow sensor in a second intake path, found on engines with two air filter boxes – for example the Nissan VR30DDTT twin-turbo V6 (where sensor B belongs to bank 2) or GM's 3.0 litre twin-turbo V6. P010C means the signal of sensor B is below its electrical lower limit – the counterpart of P0102. GM's twin-turbo V6 sets it at 400 Hz or less (300 failed out of 375 samples, two trips); Ford's digital sensor B below 1.5 kHz for 5 s. The usual causes are an open or grounded signal wire, a corroded connector, missing supply or failed sensor electronics. The engine continues with a calculated substitute value.

## Common Symptoms
- Check engine light on
- Lack of power, substitute value mode
- Rough idle, hesitation

## Most Likely Root Causes
- Signal wire of sensor B open or grounded, connector corroded
- Sensor B electronics failed
- Supply or ground of sensor B faulty
- Control module input faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor B.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor B.
5. Clear fault memory and run a verification cycle to confirm P010C does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$159 | $43–$378 |
| GBP | £13–£125 | £34–£301 |
| CAD | CA$22–CA$213 | CA$58–CA$508 |
| EUR | €15–€147 | €40–€350 |
| CHF | CHF 17–CHF 169 | CHF 53–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P010C?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P010C?
DIY replacement parts average $16–$159, while professional service averages $43–$378.

### Will resetting P010C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

