# OBD-II P010A: Mass or Volume Air Flow Sensor B Circuit

> **Quick Answer:** OBD-II fault code P010A indicates Mass or Volume Air Flow Sensor B Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p010a
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor B is a second mass air flow sensor in a second intake path, found on engines with two air filter boxes – for example the Nissan VR30DDTT twin-turbo V6 (where sensor B belongs to bank 2) or GM's 3.0 litre twin-turbo V6. P010A is the general circuit fault of sensor B: no usable signal at all, just like P0100 for sensor A. Ford's 2020–2023 petrol summary lists it for a broken element of digital sensor B, with the same limit as sensor A (period above 1.3 ms for half a second); which engines carry sensor B is not stated. GM's twin-turbo V6 only uses the other sensor B codes. The engine can run on values calculated from manifold pressure, throttle and the remaining sensor.

## Common Symptoms
- Check engine light on
- Lack of power, hesitation (substitute value)
- Rough idle
- Start-stop may be disabled

## Most Likely Root Causes
- Connector or wiring of sensor B open
- Sensor B faulty internally (broken element)
- Supply of sensor B missing (fuse, relay)
- Control module input faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor B.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor B.
5. Clear fault memory and run a verification cycle to confirm P010A does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$159 | $43–$378 |
| GBP | £13–£125 | £34–£301 |
| CAD | CA$22–CA$213 | CA$58–CA$508 |
| EUR | €15–€147 | €40–€350 |
| CHF | CHF 17–CHF 169 | CHF 53–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P010A?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P010A?
DIY replacement parts average $16–$159, while professional service averages $43–$378.

### Will resetting P010A fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

