# OBD-II P0109: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Intermittent

> **Quick Answer:** OBD-II fault code P0109 indicates Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Intermittent. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p0109
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0109 counts brief range violations of the signal that are too short for P0107/P0108 – the typical signature of a loose contact. Ford counts excursions below 0.024 V or above 4.96 V and sets the code after 25 events per drive cycle (2020–2023; ten in 2012). Ford treated it as a code without warning light in 2012 but lights the MIL in 2020–2023, so the warning-light behaviour depends on the manufacturer. GM does not use P0109 in the tables checked; there short dropouts accumulate in P0107/P0108.

## Common Symptoms
- Check engine light on (depending on manufacturer)
- Occasional hesitation or stumble
- Fault comes and goes

## Most Likely Root Causes
- Loose contact at the MAP connector, terminals spread or corroded
- Chafed or broken wire that makes contact with engine movement
- Sensor with internal dropouts
- Ground problem or control module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Manifold Absolute Pressure Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Manifold Absolute Pressure Sensor.
5. Clear fault memory and run a verification cycle to confirm P0109 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0109?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0109?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P0109 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

