# OBD-II P0108: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit High

> **Quick Answer:** OBD-II fault code P0108 indicates Manifold Absolute Pressure/Barometric Pressure Sensor Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p0108
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0108 means the signal voltage is above its upper limit – typically an open ground (low reference), a signal wire shorted to 5 V or battery voltage, or a failed sensor. Like P0107 it describes the voltage, not real overpressure; genuinely excessive boost is P0234. Documented limits: GM petrol above 86 % of 5 V, GM diesel above 97 %, GM/Saab 2.0T above 4.80 V for 4 s, Ford above 4.88–4.96 V for 5 s. The engine substitutes a modelled value, which often makes the mixture too rich; turbo engines limit boost.

## Common Symptoms
- Check engine light on
- Rich mixture, sooting, higher consumption
- Rough idle, loss of power or limp mode on turbo engines

## Most Likely Root Causes
- Ground (low reference) wire open or connector corroded
- Signal wire shorted to 5 V or battery voltage
- MAP sensor failed internally
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Manifold Absolute Pressure Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Manifold Absolute Pressure Sensor.
5. Clear fault memory and run a verification cycle to confirm P0108 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0108?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0108?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P0108 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

