# OBD-II P0107: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Low

> **Quick Answer:** OBD-II fault code P0107 indicates Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p0107
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0107 means the signal voltage is below its lower limit. 'Low' refers to the voltage, not to a real low pressure: typically the signal wire is grounded, the signal or 5 V reference is open, or the sensor has failed. A short on another sensor sharing the same reference can pull it down too, so GM often sees several codes at once. Documented limits: GM below 3.3 % of 5 V (about 0.17 V), GM/Saab 2.0T below 0.19 V for 4 s, Ford petrol below 0.19 V for 5 s, Ford diesel below 0.1 V. GM petrol needs two trips, GM diesel one. A modelled value replaces the reading.

## Common Symptoms
- Check engine light on
- Hard starting, rough idle, stalling possible
- Wrong mixture from substitute value, higher consumption
- Loss of power or limp mode on turbo and diesel engines

## Most Likely Root Causes
- Connector unplugged or corroded, signal or reference wire open
- Signal wire shorted to ground (chafing)
- 5 V reference shorted by another faulty sensor on the same circuit
- MAP sensor failed internally
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Manifold Absolute Pressure Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Manifold Absolute Pressure Sensor.
5. Clear fault memory and run a verification cycle to confirm P0107 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0107?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0107?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P0107 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

