# OBD-II P0106: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P0106 indicates Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0106
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0106 is a plausibility fault: the signal is electrically valid but implausible – stuck, offset or drifting. Two tests are common. With the engine stopped, all pressures equalise, so MAP must match ambient (and boost) pressure; Ford allows 1.5–3 inHg. While running, MAP is compared with a value modelled from air mass, throttle and speed – GM blames the MAP sensor above about 23–30 kPa error, with two trips on petrol and one on diesel. Turbo engines with three sensors find the odd one out by majority. Besides the sensor, intake or boost leaks often cause it.

## Common Symptoms
- Check engine light on
- Rough idle, hesitation, poor response
- Higher consumption, black smoke possible on diesels
- Loss of power or limp mode on turbo engines

## Most Likely Root Causes
- Vacuum leak at the intake manifold or boost leak (hose, clamp, charge air cooler)
- Sensor oiled or sooted, port blocked (EGR soot), characteristic drifted
- High resistance in signal, reference or ground wire
- Comparison sensor wrong, or mechanical cause (dirty throttle, EGR stuck open)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Manifold Absolute Pressure Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Manifold Absolute Pressure Sensor.
5. Clear fault memory and run a verification cycle to confirm P0106 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0106?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0106?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P0106 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

