# OBD-II P0105: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit

> **Quick Answer:** OBD-II fault code P0105 indicates Manifold Absolute Pressure/Barometric Pressure Sensor Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p0105
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0105 is the general circuit fault and is rarely used today: most petrol engines report low, high and intermittent separately (P0107–P0109). It appears mainly where the fault cannot be broken down further – Ford's 2023 diesels set it when the digital SENT sensor reports a bad status or an out-of-limit value for 5 s (lost communication is a separate U code), and Bosch EDC16 diesels use it with a fault type byte, for example signal below 0.2 V. Saab then substitutes 101.3 kPa, limits torque and switches off EGR and boost control.

## Common Symptoms
- Check engine light on
- Loss of power, limp mode with torque limit (diesel)
- Rough idle, hard starting, higher consumption (petrol)
- Smoke possible on diesels

## Most Likely Root Causes
- Connector or wiring to the sensor open, shorted or loose
- MAP sensor faulty (oiled, failed internally, SENT status fault)
- Sensor hose disconnected, vacuum or boost leak
- 5 V reference pulled down by another sensor on the same circuit
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Manifold Absolute Pressure Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Manifold Absolute Pressure Sensor.
5. Clear fault memory and run a verification cycle to confirm P0105 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0105?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0105?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P0105 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

