# OBD-II P0104: Mass or Volume Air Flow Sensor A Circuit Intermittent

> **Quick Answer:** OBD-II fault code P0104 indicates Mass or Volume Air Flow Sensor A Circuit Intermittent. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0104
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The mass air flow sensor (MAF) sits between the air filter and the throttle or compressor and measures how much air the engine draws in; fuel quantity, load and ignition are calculated from it. Most are hot-film or hot-wire sensors that output either a voltage or, on GM, Saab and newer Ford systems, a frequency. P0104 covers brief dropouts or jumps in the signal without a permanent low or high fault – the classic sign of a loose contact. In Ford's 2020–2023 petrol summary the code is set once more than 25 short open or short-circuit events have been counted. GM and Saab do not list P0104 in the documents checked; there such dropouts end up under P0102/P0103 or P0101. The trip count is not stated by Ford. Diagnosis means moving the harness while watching the live signal and checking terminals for corrosion and weak tension.

## Common Symptoms
- Check engine light on, may go out again
- Occasional hesitation, misfire-like stumble, flat spot
- Intermittent rough idle or stalling

## Most Likely Root Causes
- Loose contact at the sensor connector (corrosion, spread terminals, broken latch)
- Chafed or partly broken wire moved by the engine
- Sensor electronics dropping out (temperature-dependent)
- Poor ground or electrical interference

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor.
5. Clear fault memory and run a verification cycle to confirm P0104 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0104?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0104?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P0104 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

