# OBD-II P0103: Mass or Volume Air Flow Sensor A Circuit High

> **Quick Answer:** OBD-II fault code P0103 indicates Mass or Volume Air Flow Sensor A Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0103
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The mass air flow sensor (MAF) sits between the air filter and the throttle or compressor and measures how much air the engine draws in; fuel quantity, load and ignition are calculated from it. Most are hot-film or hot-wire sensors that output either a voltage or, on GM, Saab and newer Ford systems, a frequency. P0103 means the signal is above its electrical upper limit. Documented limits: GM petrol 14,500 Hz or more, GM diesel above 12,500 Hz, Saab 9-4X above about 15,150 Hz, Ford analogue above 4.785 V (checked only below 4,000 rpm so that high load is not mistaken for a fault). Typical causes are a signal wire shorted to a voltage source, failed sensor electronics or interference from a harness routed too close to ignition coils, relays or motors. GM and Saab need two trips; the engine switches to a calculated air mass.

## Common Symptoms
- Check engine light on
- Substitute value mode, lack of power
- Rich mixture possible (smoke, consumption)
- Rough idle, hesitation

## Most Likely Root Causes
- Signal wire shorted to voltage or to the supply wire
- Sensor electronics failed
- Interference from harness routed near ignition coils, relays or motors
- Water in the connector or on the element

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor.
5. Clear fault memory and run a verification cycle to confirm P0103 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0103?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0103?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P0103 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

