# OBD-II P0100: Mass or Volume Air Flow Sensor A Circuit

> **Quick Answer:** OBD-II fault code P0100 indicates Mass or Volume Air Flow Sensor A Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0100
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The mass air flow sensor (MAF) sits between the air filter and the throttle or compressor and measures how much air the engine draws in; fuel quantity, load and ignition are calculated from it. Most are hot-film or hot-wire sensors that output either a voltage or, on GM, Saab and newer Ford systems, a frequency. P0100 means the control module gets no usable signal at all. Ford uses it for a broken sensing element on digital sensors (period longer than 1.3 ms, i.e. below about 0.78 kHz, for half a second); on GM's 3.0 V6 in the Saab 9-4X it is set at 0 Hz. Many systems with voltage sensors skip P0100 and report low or high directly. The engine then runs on air mass calculated from manifold pressure, throttle angle and speed; Ford also disables start-stop.

## Common Symptoms
- Check engine light on
- Rough idle, hesitation, lack of power (substitute value)
- Hard starting or stalling
- Higher fuel consumption

## Most Likely Root Causes
- Connector unplugged or corroded, signal or supply wire open
- Sensor faulty internally (broken element, failed electronics)
- Supply fuse or relay failed
- Control module input faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Mass Air Flow Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Mass Air Flow Sensor.
5. Clear fault memory and run a verification cycle to confirm P0100 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0100?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0100?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P0100 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

