# OBD-II P002E: B Camshaft Profile Actuator A Control Circuit Low Bank 2

> **Quick Answer:** OBD-II fault code P002E indicates B Camshaft Profile Actuator A Control Circuit Low Bank 2. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$540.

- **URL:** https://faultcodes.org/automotive/obd2-p002e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
A camshaft profile actuator switches the exhaust camshaft (camshaft B) on bank 2 between two or more fixed cam profiles with different valve lift and duration, for example by shifting a cam piece axially or by locking rocker arms or tappets with oil pressure. Unlike a camshaft phaser it does not shift the timing continuously. The second letter "A" in the title numbers the actuator on this camshaft. This code is set when the control circuit reads too low, typically because the control wire is shorted to ground. The engine usually stays on one profile, typically the base profile with low lift. Some manufacturers report these faults with their own codes instead. Bank 2 exists only on V and boxer engines.

## Common Symptoms
- Check engine light on
- Less power at high engine speed because the profile does not switch
- Higher consumption or uneven part-load running, depending on the profile
- Engine speed may be limited

## Most Likely Root Causes
- Control wire chafed through and shorted to ground
- Connector corroded or contaminated with oil
- Shorted turns in the actuator coil
- Output driver in the engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Camshaft Profile Actuator Exhaust Bank2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Camshaft Profile Actuator Exhaust Bank2.
5. Clear fault memory and run a verification cycle to confirm P002E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$227 | $54–$540 |
| GBP | £15–£179 | £43–£430 |
| CAD | CA$26–CA$305 | CA$73–CA$725 |
| EUR | €18–€210 | €50–€500 |
| CHF | CHF 21–CHF 241 | CHF 66–CHF 660 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P002E?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P002E?
DIY replacement parts average $19–$227, while professional service averages $54–$540.

### Will resetting P002E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

