# OBD-II P0029: Exhaust Valve Control Solenoid Circuit Range/Performance (Bank 2)

> **Quick Answer:** OBD-II fault code P0029 indicates Exhaust Valve Control Solenoid Circuit Range/Performance (Bank 2). Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$2700.

- **URL:** https://faultcodes.org/automotive/obd2-p0029
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
A solenoid valve routes engine oil to a valve control element on the exhaust side of bank 2. Depending on the manufacturer this is a valve lift changeover or a camshaft phaser. P0029 is a plausibility fault: the electrical control is in order, but the expected effect does not occur or comes too late. The control module recognises this from feedback such as an oil pressure switch or the camshaft sensor. Pure circuit faults of the same solenoid have their own codes. The engine usually remains drivable, but with less power and higher consumption. Bank 2 exists only on V and boxer engines.

## Common Symptoms
- Check engine light on
- Loss of power, no extra pull at higher engine speed
- Higher fuel consumption
- Rough idle possible if a phaser is affected

## Most Likely Root Causes
- Oil level too low, wrong viscosity or sludged oil
- Feedback oil pressure switch faulty or leaking (systems with switch)
- Screen in front of the solenoid clogged, or solenoid sticking
- Mechanical fault in the valve train, e.g. locking pin or phaser sticking
- Contact resistance in wiring or connector

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Valve Control Solenoid Exhaust Bank2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Valve Control Solenoid Exhaust Bank2.
5. Clear fault memory and run a verification cycle to confirm P0029 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$1134 | $54–$2700 |
| GBP | £15–£893 | £43–£2150 |
| CAD | CA$26–CA$1523 | CA$73–CA$3625 |
| EUR | €18–€1050 | €50–€2500 |
| CHF | CHF 21–CHF 1208 | CHF 66–CHF 3300 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0029?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0029?
DIY replacement parts average $19–$1134, while professional service averages $54–$2700.

### Will resetting P0029 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

