# OBD-II P0024: "B" Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)

> **Quick Answer:** OBD-II fault code P0024 indicates "B" Camshaft Position - Timing Over-Advanced or System Performance (Bank 2). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$1944.

- **URL:** https://faultcodes.org/automotive/obd2-p0024
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine control module compares the commanded position of the exhaust camshaft on bank 2 with the actual position it calculates from the camshaft and crankshaft sensors. This code is set when the camshaft sits further advanced than commanded for longer than a calibrated time, or, depending on the manufacturer, when the target is missed in either direction ("system performance"). Typical cause is a phaser that does not return to its rest position, for example because the oil control valve sticks open or its screen is clogged. Bank 2 exists only on V and boxer engines; it is the cylinder bank without cylinder 1.

## Common Symptoms
- Check engine light on
- Rough idle and hesitation
- Engine may stall at idle
- Rattling from the timing drive at cold start
- Higher fuel consumption

## Most Likely Root Causes
- Oil level too low, oil sludged or wrong viscosity
- Screen at the oil control valve clogged with debris
- Oil control valve mechanically sticking
- Cam phaser worn or its locking pin sticking
- Timing chain worn or fitted incorrectly after a repair

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Cam Phaser Exhaust Bank2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Cam Phaser Exhaust Bank2.
5. Clear fault memory and run a verification cycle to confirm P0024 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$816 | $65–$1944 |
| GBP | £18–£643 | £52–£1548 |
| CAD | CA$30–CA$1096 | CA$87–CA$2610 |
| EUR | €21–€756 | €60–€1800 |
| CHF | CHF 24–CHF 869 | CHF 79–CHF 2376 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0024?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0024?
DIY replacement parts average $23–$816, while professional service averages $65–$1944.

### Will resetting P0024 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

