# OBD-II P0018: Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A)

> **Quick Answer:** OBD-II fault code P0018 indicates Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A). Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$4320.

- **URL:** https://faultcodes.org/automotive/obd2-p0018
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine control module checks whether the signal of the intake camshaft on bank 2 (sensor A) arrives at the expected crankshaft position, usually while the camshaft phaser is in its rest position. P0018 is set when the deviation stays outside a calibrated window. The camshaft is then out of step with the crankshaft: a timing belt or chain has jumped a tooth, the chain is stretched, the phaser is stuck at an end stop, or a reluctor wheel has slipped. On engines with a single camshaft, sensor A is simply the only camshaft sensor. Bank 2 exists only on V and boxer engines.

## Common Symptoms
- Check engine light on
- Long cranking or hard starting
- Rough idle and loss of power
- Chain rattle at cold start on chain-driven engines
- Risk of valve damage on interference engines if the timing has jumped

## Most Likely Root Causes
- Timing chain stretched, or belt or chain jumped a tooth
- Camshaft phaser stuck at an end stop, oil control valve or oil pressure faulty
- Incorrect assembly after a belt or chain replacement
- Camshaft or crankshaft sensor signal disturbed
- Reluctor wheel on crankshaft or camshaft slipped

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Timing Chain.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Timing Chain.
5. Clear fault memory and run a verification cycle to confirm P0018 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$1814 | $65–$4320 |
| GBP | £18–£1428 | £52–£3440 |
| CAD | CA$30–CA$2436 | CA$87–CA$5800 |
| EUR | €21–€1680 | €60–€4000 |
| CHF | CHF 24–CHF 1932 | CHF 79–CHF 5280 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0018?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0018?
DIY replacement parts average $23–$1814, while professional service averages $65–$4320.

### Will resetting P0018 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

