# OBD-II P0002: Fuel Volume Regulator A Control Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P0002 indicates Fuel Volume Regulator A Control Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $108–$3240.

- **URL:** https://faultcodes.org/automotive/obd2-p0002
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. With P0002 the circuit is electrically intact, but command and effect do not match: the measured current does not fit the duty cycle, or rail pressure does not follow the regulator position plausibly. The cause is often mechanical, for example a sticking valve, rather than the wiring.

## Common Symptoms
- Check engine light on
- Loss of power or limp mode
- Jerking or unstable idle
- Hard starting or stalling

## Most Likely Root Causes
- Regulator sticking or worn due to dirt, debris or water in the fuel
- High resistance at connector or wiring causing wrong current
- Low-pressure supply problem: clogged filter or air in the fuel
- Rail pressure sensor reading wrong values

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fuel Volume Regulator.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fuel Volume Regulator.
5. Clear fault memory and run a verification cycle to confirm P0002 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $38–$1361 | $108–$3240 |
| GBP | £30–£1071 | £86–£2580 |
| CAD | CA$51–CA$1827 | CA$145–CA$4350 |
| EUR | €35–€1260 | €100–€3000 |
| CHF | CHF 40–CHF 1449 | CHF 132–CHF 3960 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0002?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0002?
DIY replacement parts average $38–$1361, while professional service averages $108–$3240.

### Will resetting P0002 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

