# OBD-II B0016: Right Front/Passenger Frontal Deployment Loop Short to Ground

> **Quick Answer:** OBD-II fault code B0016 indicates Right Front/Passenger Frontal Deployment Loop Short to Ground. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$1296.

- **URL:** https://faultcodes.org/automotive/obd2-b0016
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Body Control, Airbag & Comfort
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The public J2012 code lists skip B0016. General Motors used it in two generations with different meanings. In older modules, documented for the Saab 9-5 2006 and the Saab 9-3 up to 2011, B0016 means low resistance in the passenger frontal stage 1 loop: the reading drops under about 1.5 ohms, tolerance 0.2, for two seconds. That is close to the title, since a short to ground or between the leads also pulls the measured resistance down. In later GM modules (Saab 9-4X 2011) B0016 is the left roof rail airbag loop, with its own bytes for short to ground (02) and low resistance below 1.4 ohms (0E). GM bulletin 08-09-41-002H lists B0016 among codes caused by unseated connector locks on many 2005-14 GM models. The airbag lamp is on in every case.

## Common Symptoms
- Airbag warning lamp on
- Passenger frontal airbag stage 1 (older GM) or left head airbag (later GM) may not deploy
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

## Most Likely Root Causes
- Squib leads shorted together or to ground in the passenger frontal loop (older GM)
- Connector position assurance lock not seated (GM 08-09-41-002H)
- On later GM vehicles fault in the left roof rail airbag loop

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Passenger Airbag Module.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Passenger Airbag Module.
5. Clear fault memory and run a verification cycle to confirm B0016 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$544 | $86–$1296 |
| GBP | £24–£428 | £69–£1032 |
| CAD | CA$41–CA$731 | CA$116–CA$1740 |
| EUR | €28–€504 | €80–€1200 |
| CHF | CHF 32–CHF 580 | CHF 106–CHF 1584 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code B0016?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair B0016?
DIY replacement parts average $30–$544, while professional service averages $86–$1296.

### Will resetting B0016 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

