# OBD-II B0015: Passenger Knee Airbag Deployment Control

> **Quick Answer:** OBD-II fault code B0015 indicates Passenger Knee Airbag Deployment Control. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$756.

- **URL:** https://faultcodes.org/automotive/obd2-b0015
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Body Control, Airbag & Comfort
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
B0015 does not appear in the public J2012 code lists, which assign the passenger knee airbag to B0013. Only General Motors documents the number, as the firing loop of the belt pretensioner built into the driver's retractor. In the Saab 9-4X 2011 manual this pretensioner shares one diagnostic page with B001A, the anchor pretensioner, and both trip when their loop stays outside the allowed resistance band or touches supply or ground for two seconds. On the 2009-11 Impala GM notes that B0015 points to the retractor pretensioner while a second pretensioner sits at the belt anchor (PIC5396A). On an Equinox, a wire under the power seat rubbing on the seat motor set B0014 and B0015 and blew the seat fuse (PIT4898C). A passenger knee airbag under this number is not publicly documented. The airbag lamp is on.

## Common Symptoms
- Airbag warning lamp on, sometimes intermittent
- On GM, belt pretensioner may not fire; power seat may fail if the harness is shorted
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

## Most Likely Root Causes
- On GM vehicles loose or corroded connector at the driver belt pretensioner
- Harness under the power seat rubbing on frame or seat motor (GM PIT4898C)
- Internal fault in the pretensioner or airbag served by this loop

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Knee Airbag Module.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Knee Airbag Module.
5. Clear fault memory and run a verification cycle to confirm B0015 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$318 | $86–$756 |
| GBP | £24–£250 | £69–£602 |
| CAD | CA$41–CA$426 | CA$116–CA$1015 |
| EUR | €28–€294 | €80–€700 |
| CHF | CHF 32–CHF 338 | CHF 106–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code B0015?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair B0015?
DIY replacement parts average $30–$318, while professional service averages $86–$756.

### Will resetting B0015 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

