# OBD-II B0014: Driver Knee Airbag Deployment Control

> **Quick Answer:** OBD-II fault code B0014 indicates Driver Knee Airbag Deployment Control. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$972.

- **URL:** https://faultcodes.org/automotive/obd2-b0014
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Body Control, Airbag & Comfort
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
B0014 is not in the public J2012 code lists; there the driver knee airbag has B0004 and the passenger knee airbag B0013. The number is documented only at General Motors, and with another meaning. GM modules from about 2010 use B0014 for the side airbag in the driver seat; the Saab 9-4X 2011 manual adds a fault byte for each failure, from a shorted or open loop to a high reading (0D, over 4.2 ohms) or a low one (0E, under 1.4 ohms). GM bulletins blame chafed or loose seat harness connectors and high connector resistance on Silverado and Tahoe 2014-15, Equinox, Traverse and the Bolt EV. Older Saab 9-3 modules used B0014 for a short in the passenger frontal stage 2 loop. A knee airbag meaning for this code is not publicly documented.

## Common Symptoms
- Airbag warning lamp or service airbag message, often intermittent
- Affected airbag may not deploy
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

## Most Likely Root Causes
- On GM vehicles loose or high-resistance side airbag connector under or in the driver seat
- Seat harness chafed by seat frame, motor or foam
- Internal fault in the airbag module served by this loop

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Knee Airbag Module.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Knee Airbag Module.
5. Clear fault memory and run a verification cycle to confirm B0014 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$408 | $86–$972 |
| GBP | £24–£321 | £69–£774 |
| CAD | CA$41–CA$548 | CA$116–CA$1305 |
| EUR | €28–€378 | €80–€900 |
| CHF | CHF 32–CHF 435 | CHF 106–CHF 1188 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code B0014?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair B0014?
DIY replacement parts average $30–$408, while professional service averages $86–$972.

### Will resetting B0014 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

