# OBD-II B0012: Passenger Frontal Stage 3 Deployment Control

> **Quick Answer:** OBD-II fault code B0012 indicates Passenger Frontal Stage 3 Deployment Control. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $108–$1404.

- **URL:** https://faultcodes.org/automotive/obd2-b0012
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Body Control, Airbag & Comfort
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
In the J2012 order B0012 is the third element of the front passenger airbag. Mercedes-Benz uses B001213 for the squib of the vent valve in that airbag, and Mitsubishi lists B0012 as passenger airbag module 3. GM gives the number a different meaning. Its later sensing and diagnostic modules assign B0012 to stage 1 of the steering wheel airbag; the Saab 9-4X 2011 manual trips it after two seconds of contact with supply or ground, an open, more than 4.4 ohms or less than 1.7 ohms; GM bulletins link it to chafed coil wires on the 2009 Cobalt and to weak terminal tension at the coil connector on the 2015 CTS. Older Saab 9-3 modules used B0012 for low resistance in the passenger stage 2 loop. Read the code with the maker's tool before choosing which airbag to check.

## Common Symptoms
- Airbag warning lamp on
- Depending on maker, passenger airbag venting or GM driver airbag stage 1 affected
- Safety note: do not probe the airbag circuit yourself; unplug airbag connectors only with the battery disconnected and the stated wait time observed

## Most Likely Root Causes
- Open or shorted third squib (vent valve) in the passenger airbag (J2012 meaning)
- On GM vehicles weak terminal tension or chafed wires at the steering wheel airbag coil
- Restraint control module fault

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Passenger Airbag Module.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Passenger Airbag Module.
5. Clear fault memory and run a verification cycle to confirm B0012 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $38–$590 | $108–$1404 |
| GBP | £30–£464 | £86–£1118 |
| CAD | CA$51–CA$792 | CA$145–CA$1885 |
| EUR | €35–€546 | €100–€1300 |
| CHF | CHF 40–CHF 628 | CHF 132–CHF 1716 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code B0012?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair B0012?
DIY replacement parts average $38–$590, while professional service averages $108–$1404.

### Will resetting B0012 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

